Southern State Sdn. Bhd.
9, 11 & 15, Lorong 1, Jalan Dewani, Off Jalan Tampoi, Majidee, 81100 Johor Bahru, Johor, Malaysia.
+607-332 1154 / 0984+607-334 3834
+607-331 6966
+6012-7966929(Mr. Yono/ Ms. Aini)
CLSB回油式电动注油机
| 上一页 | 2 / 4 | 下一页 |
- The standards assemble with 1/4 HP motor and TOP-10 A rotary oil pump, the flow rate could be 1.2 to 1.4 L/min. The type of motor and oil pump also could be chosen on request. Please look the specification for details.
- There are two types: CLSA Vertical-Motor and CLSB Horizontal-Motor type circulating electric lubricator.
- This is circulating lubricator, which means the oil flows out, then comes back into the oil tank through the cyclic inlet, thus could save the usage volume of oil. The cyclic inlet has magnetic filter, which can block the impurities and assure the oil clean.
- After installing and connecting the oil pipe, feed oil till oil flows out, then start to use this lubricator.
- It used a high quality pump that not only has steady output pressure and low noise, but also can assure each lubrication point with output of oil. It can be applied for large machines' request.
- It has a pressure-regulating valve, which can adjust the pressure and easy to check from the pressure gauge.
- It has a float switch that can detect the volume of oil. It will have abnormal signal automatically when the oil level is lower than the standard.
- The standards assemble with 1/4 HP motor and TOP-10 A rotary oil pump, the flow rate could be 1.2 to 1.4 L/min. The type of motor and oil pump also could be chosen on request. Please look the specification for details.
- The standard of cyclic inlet is 3/4 inches, also can be changed to 1/2, 1, 1 1/4,1 1/2 inches.
- It can be added a buzzer on request, which will alarm when the oil level is too low.
- As ordering, please detail the voltage, pole, HP, and hertz of motor.
